Poster Hangers

Framing a poster properly means glass, mounting board and a wall anchor you will regret drilling. This corner clip set skips all of that. Four printed corners slide over each corner of your poster, and slim guide strips run along the edges to keep bigger prints dead straight, so the paper sits flat against the wall with nothing showing but a clean, boxed edge. Each clip is 3D printed in PETG Basic, chosen because these are working hardware, not ornaments. They get pressed on, pulled off and swapped between posters more than almost anything else on your wall, so we wanted a filament with the toughness to take that handling without cracking at the corner. Mounting is simple: stick the clips to the wall with the adhesive you already use for command strips or double-sided tape, then slide your poster into place. No frame, no glass, no drilling. Perfect for gig posters, gallery prints, movie art or that oversized print that never quite fit a standard frame. Printed to order in Australia in a set of four corners plus guide strips sized to your poster. Choose a colour that disappears against your wall, or one that reads as a deliberate design detail.