Nina | Toothbrush Cups

Shared toothbrush cups have a dirty secret: bristles end up jammed together and the bottom turns into a damp, grimy puddle. Nina's cup fixes both problems with one clever trick. It is printed as a single continuous wall in vase mode, which naturally folds into a ring of rounded lobes, so every toothbrush gets its own private pocket and never touches its neighbour. Because each lobe is open along its length, water runs straight down and out instead of collecting in a sealed base. A wider slot in the centre holds a toothpaste tube upright instead of letting it topple into the sink, and on the 6 brush version there is room left over for a razor too. Nina comes in three sizes to match your household: a 3 brush cup for a couple sharing a small vanity, a 4 brush cup for a family bathroom, and a 6 brush cup for a full house (or a couple who like their gear organised). Each one measures a neat 110mm across and 110mm tall, so it sits comfortably on most benchtops. We print Nina in PETG Basic, a plastic that shrugs off the condensation and splashes that come standard in any bathroom. The vase mode finish leaves smooth, rippled ridges rather than a stack of visible layer lines, so it looks considered rather than 3D printed. Printed to order in Australia and ready in 1 to 2 days, in a colour that suits your bathroom.