Naked Pendant Lamp

Some fixtures hide the bulb. This one puts it centre stage. The Naked Pendant Lamp is a 3D printed cylinder that slides over a standard E27 lampholder, leaving the exposed filament bulb and its twisted cord to do the talking below. There is nothing to disguise here, and that is the point. The sleeve is printed in ABS rather than a purely decorative plastic, because it sits right where a bulb runs warm hour after hour. The result is a smooth, matte cylinder that keeps its crisp edges and true colour even after months of daily use. Order it in Matte Black for a deep monochrome look, Traffic Red for a bold pop against a plain ceiling, Volcanic Rock Grey for raw concrete warehouse style, or Bronze if you want a hint of aged metal without the tarnish. Each colour changes the whole mood of the fixture while the honest, no frills silhouette stays the same. Hang it low over a kitchen island, cluster three above a studio desk, or drop a single one beside the bed for a fixture that reads as considered rather than accidental. Printed to order in Australia and usually ready within a couple of days, it slips straight onto your existing pendant cord, no rewiring required.