Back to Products
IMG_20250722_091916

Cute Egg Planter

A grinning eggshell buddy with waving hands and tiny feet, ready to hold a succulent on your desk.

Half hatched and full of personality, this little egg has cracked itself open just enough to make room for a plant. Its jagged shell crown peels back in sharp little points, revealing a hollow centre perfect for cradling a succulent or a few dried stems. The face is the star of the show: two crescent moon eyes glued on by hand, a soft close lipped smile, and three fingered hands raised in an eternal wave. Two stubby feet poke out the front so it sits flat and steady on any shelf or desk, no wobbling required. Printed in PLA+ with a clean, bright raw finish, the detail in those jagged shell points and tiny fingers stays crisp. It is designed to scale up beautifully into a bigger showpiece, though we would not push it much smaller than the original since the fine features need the room. A genuinely fun housewarming or plant lover gift, and just as happy holding a pen cup's worth of pencils as it is a baby succulent. Printed to order in Australia in a colour to suit your space, from classic white to a softer pastel.

Product Highlights

  • Cracked eggshell design with hollow planter top
  • Cute crescent moon eyes, hand applied
  • Waving three fingered hands and sitting feet
  • Smooth raw PLA+ finish
  • Scales up beautifully for a bigger showpiece
  • Printed to order in Australia

Source & Attribution

Original Designer
In-House
View original
Open source page

Official Hive 3D Printing Commercial Licence Holder (Hive ID #FEC97JMW71)